Shark WANDVAC SELF-EMPTY SYSTEM Quick Start Manual

CORDLESS 3-IN-1
UPRIGHT
The brushroll is activated when the hand
vacuum is connected and powered on.
ABOVE-FLOOR
HAND VACUUM
To detach the hand vacuum, slide the release
tabs on both sides of the handle and lift it
off the wand. Attach an accessory by sliding
it into the nozzle. To remove the accessory,
slide the release tabs on the handle. To
reattach the hand vacuum, slide the nozzle
over the wand on until it clicks into place.
ABOVE-FLOOR
WAND
To detach the floor nozzle, step on the nozzle
while pressing the release button at the
bottom of the wand. Lift the wand to remove
it. Reattach by sliding the wand over the
nozzle neck until it clicks into place.
© 2022 SharkNinja Operating LLC. SHARK and WANDVAC are registered
trademarks of of SharkNinja Operating LLC. POWERFINS is a trademark of
SharkNinja Operating LLC.
EMPTYING THE DUST CUP
1
Place the vacuum on the dock in a downward
motion. Once properly attached, the
auto evacuation process will begin. The
evacuation cycle will last for 10 seconds.
Note: do not remove the vacuum while
the evacuation cycle is taking place.
Once evacuation is complete, the vacuum
will continue charging until it is removed
from the dock
2
With the power off, slide the release button
forward, and the dust cup will swing open. Tap the
dust screen lightly to knock off dust and debris.
3
Wipe dust screen lightly with a dry cloth
to remove dust and dirt.
WS640AE_QSG_26_MP_REV_Mv3
Please make sure to read the enclosed Shark® Owner's Guide prior to using your vacuum.
WANDVAC
®
SELF-EMPTY SYSTEM
Cordless Vacuum
QUICK
START
GUIDE
For questions, visit us online at
sharkclean.com/support
Register your vacuum at
registeryourshark.com
WS640AE
WS642AE