Sleep Operation - Haier HSU-12LR03 Operation Manual

Operation
Display board
Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
become 1 C higher than temp. setting. After
O
another 1 hours, temp. rises by 1
The unit will run for further 6 hours then stops.
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
Remote Controller
PURIFY
FRESH
POWER/SOFT
O C further.
2. In AUTO mode
3. In FAN mode
4.Set the wind speed change when sleeping
5.Note to the power failure resume:
NOTE:
14

Sleep Operation

SLEEP operation starts
Approx.6hrs
1 hr
O
Rises 1
1 hr
Temp.setting
In COOL, DRY mode
The unit operates in corresponding sleep
mode adapted to the automatically selected
operation mode.
It has no SLEEP function.
If the wind speed is high or middle before
setting for the sleep, set for lowing the wind
speed after sleeping.
If it is low wind, no change.
press the sleep button ten times in five seconds
and enter this function after hearing four sounds.
And press the sleep button ten times within five
seconds and leave this function after hearing
two sounds.
With the power failure resume, when setting
the TIMER ON, TIMER OFF and TIMER ON/OFF,
it's memorized as shutdown status when resuming
after power out.
SLEEP operation stops
O
Rises 1 C
C
Unit stop