The items indicated here are very important safety precautions, which must be followed. The following pictures are presented just for the purpose of illustration. As for some models whose cooling capacity is above 4600W(17000BTU/h), their power cables do not have a plug! So please take real objects as a reference.
For some models whose cooling capacity are above 4600W (17000BTU/h), an all-pole disconnection device which has at least 3mm separation distance in all pole and a residual current device(RCD)with the rating of above 10mA shall be incorporated in the fixed wiring according to the national rule.
Air outlet Drain opening NOTICE Appearance of the indoor unit and outdoor unit may differ with some models. 2.DISPLAY MODELS This illustration generalizes all the displays for the models included in this manual book. Please take real objects as reference while using.
NAME OF PARTS 3.EMERGENCY OPERATION SWITCH In case the batteries in the remote controller are wore out, or remote controller is at fault, use Emergency operation switch Emergency Operation switch The places of e mergency operation switch of different models maybe different, but all of the ¡...
During operation, please take real objects as major reference. Clean the front grille and air filters 1.Open the front grille by pulling the tabs on both sides and lift it up until it stops with a click. Pull out the air filters.
TROUBLE SHOOTING The following cases are not troubles that will obstruct you in using please follow the fault analysis and continue using. Fault analysis! Is there a fault? Is it a power failure? Has the power plug fallen off? Air conditioner does Has the circuit breaker or fuse shut off not operate.
During heating, water on heat exchanger will drop. If you find one of the following symptoms, please turn the breaker off quickly and call our designated service shop nearest to you for help. The power cord is overheat or damaged.
5.Wiring diagram of air conditioner (indoor unit/outdoor unit) are attached to the indoor/ outdoor unit respectively. 6.If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.