Recharging - Simons Voss Technologies SmartCD2.G2 Manual

Programming device SmartCD2.G2
(Manual)

6. Recharging

Power supply on passive USB hubs
On passive USB hubs, all connected devices share the power supply. This may result in insuffi-
cient power being available to the programming device.
Connect the programming device to an active USB hub with its own power supply or connect

it directly to a USB port of your PC/tablet/laptop.
Self-discharge of the batteries
Like all batteries, the batteries in the SmartCD2.G2 discharge over a long period of time. In this
case, you cannot use it until it is charged.
Leave the SmartCD2.G2 connected to a suitable USB port if you are not going to use it for a

longer period of time.
Connect the SmartCD2.G2 to a USB port (PC/laptop/power bank or
similar) using a USB cable. The SmartCD2.G2 batteries are then charged
via the USB port.
NOTE
USB connections are in standby or switched off
On your PC or laptop, the USB ports may be turned off in standby or off
mode.
1. Check the USB settings in your device's power plan.
2. Alternatively, use a USB charger, active USB hub, or power bank.
6. Recharging
9 / 19