Advertisement
Quick Links
EB-201JK
Mounting Bracket for VeriFone
Payment Device P400
Quick Installation Guide
Package Contents
EB-201JK Mounting Bracket Kit............................................(x 1)
#6/32 Screws...................................................................(x 8)
EB-201JK Mounting Bracket for VeriFone Payment Device P400
1.
Open the touch monitor.
For JK-24xx/27xx, unlock the touch monitor. Then you can open the
touch monitor through the direction shown in the picture below.
EB-201JK Ver. A0
1
Advertisement
Related Manuals for POSIFLEX EB-201JK
Summary of Contents for POSIFLEX EB-201JK
- Page 1 EB-201JK Mounting Bracket Kit………………………………..….(x 1) #6/32 Screws………………………………………………………….(x 8) EB-201JK Mounting Bracket for VeriFone Payment Device P400 Open the touch monitor. For JK-24xx/27xx, unlock the touch monitor. Then you can open the touch monitor through the direction shown in the picture below.
- Page 2 For JK-32xx, unlock the touch monitor. Hold two sides of the touch monitor and then gently pull it out towards you slowly. Once the crank rod stopper drops down slowly begin to release the touch monitor until it stops. Crank Rod Stopper for Touch Monitor...
- Page 3 There are four hex nuts in old version of JK series touch monitor. Remove the middle ivory metal plate of the belly system unit of the kiosk by removing four nuts. Then install the card reader holder on the empty space of the belly system unit of the kiosk with four nuts.
- Page 4 Connect the cable to the payment first, and then fix the small bracket to the rear side of the payment with two 6/32 screws.
- Page 5 Fix the payment bracket with two #6/32 screws. Make the cable pass through the cable exit when put the payment device to the kiosk. Fix the payment bracket to the kiosk with four #6/32 screws.
- Page 6 Fix the cable cover bracket with one hex nut.
- Page 7 Sort the payment device cable like the below picture.
Need help?
Do you have a question about the EB-201JK and is the answer not in the manual?
Questions and answers