Pretreatment Of Parts - Axis Q1805-LE Repainting Instructions

AXIS Q18 Series
Repaint the product
Repaint the product
Preparations
• If applicable, disassemble the device according to the instructions in this document.
• Clean all parts that will be repainted thoroughly to remove grease, dust, or oil.
• To ensure reassembly and functionality of the product, mask any openings (for example for screws, LED indicators,
or microphones) before you paint.

Pretreatment of parts

Depending on the part material and type of coating applied at factory, pretreatment might be necessary for the new coating to
adhere well. Before you apply a new coating, we recommend the following pretreatment:
1. If necessary, roughen up the surface with a light sandpaper or similar to increase adhesion. Alternatively, remove the
original coating down to base material.
2. Clean the parts properly to remove oil, grease, and dust.
3. If necessary, apply a primer layer suitable for the specific material to increase adhesion to the parts. For outdoor products,
we recommend a primer to improve corrosion resistance.
We recommend pretreatment of parts made of the following materials:
• powder coated
• wet painted
• anodised
• chromated
• stainless steel
• other metal
• plastic
The materials used in the product are powder coated aluminium and plastic with VDI27 structure.
Disassembly
Note
Be careful not to lose screws and small parts.
3