Haier AC092ACBHA Manuel D'utilisation page 21

Installation of Indoor Unit
B. For strand wiring(Fig.19B)
(1) Cut the wire with a wire cutter or wire-cutting pliers, then strip the insulation to about 10mm of the
exposed strand wiring.
(2) Using a screwdriver, remove the terminal screw(s)on the terminal board.
(3) Using a round terminal fastener or pliers, securely clamp a round terminal to each stripped wire end.
(4) Position the round terminal wire, and replace and tighten the terminal screw using a screw driver.
(Fig. 19)
Wire
HOW TO FIXED CONNECTION CORD AND POWER CABLE AT THE CORD
CLAMP
After passing the connection cord and power cable through the insulation tube, fasten it with the cord clamp,
as shown in Fig.20
(Fig. 20)
Use VW-1, 0.5 to 1.0 mm thick, PVC tube as the insulation tube.
A. Solid wire
Loop
Insulation
Screw with
special washer
Round
terminal
Terminal
board
Insulation tube
B. Strand wire
Screw with
special washer
Wire
Cord clamp
19
Round
terminal
Round
terminal