I have written this short guide to help fill in a gap I found when asking for help from Corsair's support team. I needed to replace the front I/O panel on my computer case, but wasn't sure how to access it for replacement.
Chapter 2. Prepare the Case Before removing the top bezel, you will need to prepare the case. There are two separate chambers in this computer case: • The Power Chamber: this section of the case contains the power supply, hard drives, front I/O panel, and all of the wiring for the computer.
Page 5
Corsair Crystal 680X RGB Front IO Replacement Guide | 2 - Prepare the Case | 5 Warning: Some computer components can hold an electric charge after the computer is powered down. Please ensure the power supply is turned off to reduce the chance of electric shock injury.
Chapter 3. Remove the Top Bezel You must remove the top bezel before you can access the front I/O panel. 1. Locate the top bezel tabs inside the main chamber. Tip: The tabs are long pieces of plastic with hooked ends. You can find them at the top of the inside of the case.
Page 7
Corsair Crystal 680X RGB Front IO Replacement Guide | 3 - Remove the Top Bezel | 7 There are 13 tabs to release before you can take the top bezel off. Once you have released all of the tabs, you are now ready to remove the top bezel.
7. Snap the top bezel back into place. You have replaced the front I/O panel on your Corsair Crystal 680X RGB case! You can now move your computer back to its original location, plug it in, and turn the power supply back on.
Need help?
Do you have a question about the Crystal 680X RGB and is the answer not in the manual?
Questions and answers