Related Manuals for COMPASS HEALTH DT7305
Summary of Contents for COMPASS HEALTH DT7305
- Page 1 INSTRUCTION MANUAL - for the - DT7305 TENS 7000 RECHARGEABLE + EMS TENS 7000...
-
Page 2: Table Of Contents
1.2 Medical Background 1.3 Indication for use Compass Health Brands Corp. reserves the right to improve and amend Important Safety Precautions and Warnings... . 6 it at any time without prior notice. Amendments may however be Package Contents . -
Page 3: Introduction
1. INTRODUCTION How TENS Works There is nothing “magic” about Transcutaneous Electrical Nerve 1.1 General Stimulation (TENS). TENS is intended to help relieve pain. The TENS device sends comfortable impulses through the skin to stimulate the The TENS 7000 Rechargeable + EMS is a portable electrotherapy device nerve (or nerves) in the treatment area. -
Page 4: Indication For Use
1.3 Indication for Use DANGER TENS: The device is designed to be used for temporary relief of pain associated This stimulator must NOT be used in combination with the following medical with sore and aching muscles in the shoulder, waist, back, neck, upper extremi- ties(arm) and lower extremities (leg) due to strain from exercise or normal devices: household work activities. - Page 5 WARNING (CONTINUED) CAUTION DO NOT USE THIS DEVICE DURING THESE ACTIVITIES WARNINGS AND PRECAUTIONS REGARDING THE ELECTRODES • When in the bath or shower • While sleeping • DO NOT bend or fold because the pad may not function properly. Place •...
- Page 6 CAUTION (CONTINUED) GENERAL PRECAUTIONS CAUTION WHILE USING THE STIMULATOR • The patient is an intended operator of the device. • The patient can fully operate the device，but maintenance and modification • If the stimulator is not functioning properly or you feel discomfort, of the device can only be done by a service technician authorised by the immediately stop using the device.
-
Page 7: Package Contents
REPLACEMENT PART NUMBERS NOTE: ALWAYS use electrodes that are legally marked and sold Item Number Description in the United States under 510K guidelines. DT7305 TENS 7000 Rechargeable 1 each + EMS Device WW3005 Lead wires 2/pk... -
Page 8: Front And Rear Panel
3.1 Front and Rear Panel 3.2 LCD Display TENS 7000 Lead Connector TENS/EMS mode sign On /Off/ intensity dial CH1 sign Panel Cover Active Mode Sign Liquid Crystal Display Ramp/ON/OFF settings sign Mode selection button Width/Rate settings sign Set selection button Parameter number display Increase Parameter Button Hz/˜S unit sign... -
Page 9: Specifications
4.2 Technical Specifications (TENS) 4. SPECIFICATIONS Modes (5) B (Burst), N (Normal), M (Modulation), SD1 (Strength Duration 1), SD2 4.1 Technical Information (Strength Duration 2) Burst Mode Burst Rate: Adjustable, 0.5 – 5Hz Channel Dual, isolated between channels Pulse Width: Adjustable, 50 – 300˜S Li-ion Battery 3.7V 250mAh... -
Page 10: Waveform Information (Tens)
4.4 Waveform Information (TENS) 4.5 Waveform Information (EMS) BURST SYNCHRONOUS (S) NORMAL ALTERNATE (A) MODULATION 5. INSTRUCTIONS FOR USE 5.1 Battery SD1 (STRENGTH DURATION) Battery charging Insert the TYPE-C plug of the TYPE-C cable into the TYPE-C charging port of the device, and then connect to the Standard USB plug of the TYPE-C cable to the appropriate power supply device which can output 5V d.c., 300mA at least. -
Page 11: Using Your Device
5.2 Using Your Device NOTES: • When the battery indicator is going to be empty on the LCD, please A. Panel Cover charge the battery. If the battery power is too low, the device will A panel on the front of the device covers all the operating buttons. turn off automatically. -
Page 12: To Set Tens Parameters
C. Connect Lead Wires E. Select Waveform/Mode 1) Before proceeding to this step, be sure the device is completely To choose which waveform and mode to use, press until the desired MODE turned OFF. selection is displayed on the screen. There are 5 TENS modes 2) Insert the lead wires into the output sockets located on the top (B, N, M, SD1, SD2) and 3 EMS Modes (C, S and A) to choose from. -
Page 13: To Set Ems Parameters
B. Set Pulse Rate E. Start Treatment Press After all parameters are set, to increase the intensity and start treatment, change the default number, press until the desired Pulse Rate slowly turn the dial for the corresponding channel clockwise and waiting number is displayed on the screen. - Page 14 B. Set Contraction “ON” Time D. Set Pulse Width Press Press button and the number for “Width” on the LCD screen will change the number, press until the desired contraction/”ON” until the desired time is reached. pulse width number is displayed on the screen. Note: The “ON”...
-
Page 15: Check Compliance Meter
G. Start Treatment B. Check & Delete Accumulative Record When in the individual records menu, press to switch to MODE After all parameters are set, to increase the intensity and start treatment, accumulative records menu. To delete ALL records, press slowly turn the dial for the corresponding channel clockwise and waiting then the button simultaneously for 3 seconds and ALL records... -
Page 16: Cleaning And Storage
6. CLEANING AND STORAGE CAUTION 1. The life of electrodes is dependent on many factors including, but not limited to, 6.1 Keeping Electrodes Clean cleanliness of treatment area, oiliness of skin, amount of hair, increased sweating, storage state, etc. • Ensure the device is completely turned off when removing the 2. -
Page 17: Troubleshooting
7. TROUBLESHOOTING Problem Possible Causes Possible Solution Problem Possible Causes Possible Solution Improper electrode The unit cannot Charge the device The battery is exhausted. Reposition electrode. Stimulation is placement. power on ineffective. Unknown Contact clinician. Electrodes are dried out Replace with new or dirty. -
Page 18: Disposal
8. DISPOSAL 10. ELECTROMAGNETIC COMPATIBILITY (EMC) TABLES Used fully discharged batteries MUST be disposed of in a specially labeled collection container, at toxic waste • This device should not be used adjacent to or stacked with other collection points or through an electrical retailer. You are equipment. - Page 19 TABLE 1 TABLE 2 declaration - electromagnetic emission declaration - electromagnetic immunity The device is intended for use in the electromagnetic environment specified below. The customer or The device is intended for use in the electromagnetic environment specified below. The customer or the user of device should assure that it is used in such an environment.
- Page 20 TABLE 3 TABLE 4 declaration - electromagnetic immunity Recommended separation distances between portable and mobile RF communications equipment and device The device is intended for use in the electromagnetic environment specified below. The customer or the user of device should assure that it is used in such an environment. The device is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
-
Page 21: Fcc Compliance Statement
Responsible Party follow the operating instructions, accidents, abuse, alteration or Company Name: Compass Health Brands Corp. disassembly by unauthorized personnel. Address:6753 Engle Rd Middleburg Heights, OH 44130 Phone Number: 800.871.7858 1) The limited warranty period for device is one year from date of This device complies with part 15 of the FCC Rules.
Need help?
Do you have a question about the DT7305 and is the answer not in the manual?
Questions and answers