pyrexx XSD200 User Manual page 75

be identified using the "Group connection
test" (see chapter 9.1 "Radio group con-
nection test" on page 68). If a faulty
device is identified, proceed as follows to
troubleshoot:
f In order to exclude temporary radio
interference from other radio-based
devices, perform the group connec-
tion test on another device again.
5 Connection test was successful and
all devices are functional.
or
5 Connection test was not successful,
there is a defective device in the
radio group.
(1) Reset the defective device to the
factory settings (see chapter 10
"Restoring default settings" on page
69).
(2) Remove the defective devices
allocation to the radio group (see
chapter 10.1 "Cancelling a device from a
radio group" on page 69).
(3) Re-connect the radio group with a
EN
User Manual: XSD200 - Smoke Alarm Device with Radio Link
reduced number of devices
(see chapter 10.1 "Cancelling a device
from a radio group" on page 69).
To add a replacement device to the radio
group, refer to the following chapters:
• Chapter 7 "Expanding a radio group
and learning mode" on page 66.
• Chapter 6.2 "Completing a
radio group" on page 66.
75