Fault And Error Messages - pyrexx XSD200 User Manual

5 The alarm on the triggering device
and the forwarded devices is
stopped.
If the alarm forwarding has already tak-
en place in a radio group, and you can-
not identify the alarm-triggering device,
proceed as follows:
(1) Press the testing/stop button on
a device of the subgroup or the
shared radio group.
(2) Alarm of all forwarding devices of
the radio groups is stopped.
The alarm of the alarm-trig-
gering device can only be
terminated directly on the device
in question. Thus the fire location
can be located in case of fire.
(3) Press the testing/stop button on the
device triggering the alarm.
5 The alarm on the triggering device
and the forwarding devices is
stopped.
EN
User Manual: XSD200 - Smoke Alarm Device with Radio Link
12 Fault and error
messages
The device automatically checks its op-
erational readiness once a minute. The
device displays functional limitations in
the form of error and alarm messages.
If the device detects environmental influ-
ences differing from the rule, it regulates
the sensitivity of its detection electronics
automatically.
12.1 Error messages
The following messages are considered
error messages:
Battery error message
•
Contamination message
•
Alarm without cause of fire
•
Defective connection test
•
of a radio group
71