Loading The Paper - Kodak Professional ML-500 Operator's Manual

Loading the Paper

April 2002
CAUTION
:
Use only paper designed for the ML-500 digital photo print
system. Using other materials may cause problems.
For the correct orientation and location of the paper roll,
IMPORTANT:
see Media Loading Instructions on the CD or inside the
printer door.
Open the printer door.
1.
Turn the paper drawer locking knob counterclockwise several times,
2.
then pull the drawer outward until it locks into position.
Grasp the paper roll with the leading edge over the top of the roll facing
3.
away from you.
Set the paper roll into the drawer on the guide rails.
4.
Turn the pressure roller lever counterclockwise to fit the paper between
5.
the pressure roller and the drive roller.
Wrap the leading edge of the paper roll around the four rubber rollers.
6.
Make sure the paper is not under the metal drawer slide.
Position the leading edge of the paper between the pressure roller and
7.
the drive roller.
Align the sides of the paper with the guide marks on the paper alignment
8.
plates.
Turn the pressure roller lever clockwise to clamp the paper into position.
9.
Turn the drive roller knob clockwise to position the leading edge of the
10.
paper to the front edge of the alignment plate.
Turn the paper roll tension knob clockwise to remove the slack.
11.
Turn each ribbon take-up spool counterclockwise on all four ribbon
12.
modules until tight.
Release both drawer latches to slide the drawer into the printer about 1
13.
inch (2.54 cm).
Turn the paper roll tension knob clockwise until the web is completely
14.
snug, then push the drawer into the printer while holding the knob.
Turn the paper drawer locking knob clockwise several times until tight.
15.
Close the printer door.
16.
Setting up the Printer
2-7