Information About Frequency Bands (4G/Lte & 3G) - Enlaps Tikee mini User Manual

8. Informations about frequency bands ( 4G/LTE & 3G)
Radio-Frequency technologies embedded in Tikee mini device :
RF technology
WIFI
3G/4G
BLUETOOTH
GPS
ENLAPS Tikee
FCC ID : 2ASLI-TIKEE002
IC : 24785-TIKEE002
Note - Modular Approval :
Contains :
FCC ID : 2AJYU-8PYA007
IC : 23761-8PYA008
FCC ID : S9NBNRGM2SA
IC : 8976C-BNRGM2SA
Caution: the user that changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception which can be determined by turning
the equipment off and on, the user is encouraged to try to correct interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
- Connect the equipment into an outlet on circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC RF radiation exposure limits set forth for general population. This
device must be installed to provide a separation distance of at least 20cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
Frequency bands
2.4-2.4835Ghz
LTE-FDD: B1/B2/B3/B4/B5/B7/
B8/B12/B13/B18/B19/ B20/B25/
B26/ B28/B66
LTE-TDD: B34/B38/B39/ B40/B41
UMTS/HSPA+ : B1/B2/B4/B5/B6/
B8/B19
2.4Ghz
1.57542GHz
equipment and receiver.
Informations about frequency bands
Max power
17.2 dBm (EIRP)
-34.3 dBm (ERP)
-1.1 dBm (EIRP)
Reception Only
26