Setting Up The Connection Of Your Tikee Mini To Mytikee - Enlaps Tikee mini User Manual

3. You access directly to the status screen of your Tikee :
Tikee mini's name
/ serial number
Firmware release
of Tikee mini
Remaining battery
percentage
The Tikee mini has 2 possible status:
- STOP : basic status of the Tikee mini, in inactive mode the camera will not take a photo
sequence and will switch off after 30 minutes of inactivity. You will have to access the camera
and press the power button to start it again
- START : this mode allows the Tikee mini to remain on and therefore to take into account
the sequences set up ( see
connects to the cloud at least every 24 hours to retrieve new information (for example, adding a
new sequence from myTikee).
To switch between the two status, press « START » or « STOP » on the mobile app.
Warning : If the Tikee mini turns off while it was on STOP, you will need to access the camera
and press the power button to turn it back on.

Setting up the connection of your Tikee mini to myTikee

If you want use your Tikee mini's WiFi modem or 4G LTE modem to regularly upload photos to
myTikee cloud platform, you have to complete the following settings.
Active connectivity mode is displayed on the mobile application screen (None, Wifi or LTE)
Select the desired connection mode (wifi or LTE) and set up the connection, save and test it.
!
Please contact your operator for connecion settings.
page 15). If no sequence is in progress or programmed, the device
None Wifi LTE
Getting started with the mobile app Tikee Remote
To disconnect from Tikee
mini
Tikee mini's status
Available space on the
memory card
Note: it should remain at least 200MB
of free space to start a sequence
Prévisualisation
10