Update Your Tikee Mini - Enlaps Tikee mini User Manual

Table of Contents

Advertisement

Update your Tikee mini

Before using the Tikee mini, check that its firmware version is the latest online (see
If this is not the case, update your Tikee mini :
Note :
To update your camera, make sure the battery charge level is above 50%.
- From the microSD card
Go to our website https://enlaps.io/en/download, download the update according to your
camera model from a computer following the instructions given, copy it on the microSD card
previously formatted (see formatting chapter). You can also download the update from the
myTikee cloud platform.
Note :
The file must be named exactly «TikeeUpdate.fw». Be careful, some browsers may rename
the file when downloading the same file successively.
1
Camera off -
2 Turn on your Tikee mini and and from the mobile app, go to :
The update may take a few minutes. Once finished, you will receive a notification on the mobile
application and then it will disconnect.
Tikee mini will restart automatically (the Power LED will go out and then start flashing before
becoming steady again).
Once the update is complete, you can reconnect to the Tikee Remote mobile application. The
update file is automatically deleted from the microSD card once it is done.
- From the cloud via the Tikee Remote mobile application
This method requires a valid Wi-Fi or 4G/LTE connection and a microSD card into the slot SD.
Stand close to your Tikee mini and launch the update from the cloud. The update is done
following the steps displayed on the screen.
Caution/Important :
plug because the update is only done if the battery level is higher than 50%
Note :
On some smartphones, after an update, switch to the airplane mode 30 seconds before
reconnecting to the mobile application.
- From the cloud via the myTikee cloud platform
This method is possible if the Always-ON is set up on your Tikee mini.
1 Go to your myTikee account
My Tikee
2 Select «
3 Click on « Always On », then select «
Your Tikee mini will connect to myTikee to download the latest firmware version within a few
minutes. It will then install the new software and reconnect to the platform.
From SD
Insert the microSD card into the dedicated slot.
In both cases, it is recommended to connect your Tikee mini to a USB
» in the left-hand menu and click on your camera's serial number.
Upgrade firmware
Getting started with the mobile app Tikee Remote
Software update
From SD
From cloud
» and click on «
page
From cloud
Validate
».
14).
14

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Tikee mini and is the answer not in the manual?

Table of Contents