Kodak EASYSHARE ONE User Manual page 105

Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. Where shielded
interface cables have been provided with the product or specified additional
components or accessories elsewhere defined to be used with the installation of the
product, they must be used in order to ensure compliance with FCC regulation.
CAUTION:
When using the Wi-Fi card with a printer dock: This equipment should
be installed and operated with a minimum distance of 7.9 inches (20
cm) for 2.4 GHz operations between the radiator and your body. This
transmitter must not be collocated or operate in conjunction with any
other antenna or transmitter.
SAR statement (when using with Wi-Fi card)
The available scientific evidence does not show that any health problems are
associated with using low power wireless devices. There is no proof, however, that
these low power wireless devices are absolutely safe. Low power wireless devices
emit low levels of radio frequency energy (RF) in the microwave range while being
used. Whereas high levels of RF can produce health effects (by heating tissue),
exposure to low-level RF that does not produce heating effects causes no known
adverse health effects. Many studies of low-level RF exposures have not found any
biological effects. Some studies have suggested that some biological effects might
occur, but such findings have not been confirmed by additional research. Kodak
®
Wi-Fi card (3F8508) has been tested and found to comply with FCC radiation
exposure limits set forth for an uncontrolled equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in Supplement C to OET65. The maximum SAR
levels tested for Kodak Wi-Fi
Body.
www.kodak.com/go/support
®
card (3F8508) have been shown to be 0.616 W/kg at
Appendix
98