Replacing The Lamp Socket Terminal Assembly; Installing The Lamp Socket Terminal Assembly - Kodak CAROUSEL NEW LOOK PROJECTOR Service Manual

SERVICE MANUAL

Replacing the LAMP SOCKET TERMINAL ASSEMBLY

Style 1 LAMP SOCKET TERMINAL ASSEMBLY
SCREW
TAB (2)

Installing the LAMP SOCKET TERMINAL ASSEMBLY

[1] Do the replacement procedure for the LAMP SOCKET TERMINAL ASSEMBLY in reverse order.
18
LAMP DOOR
PLATE ASSEMBLY
PROJECTOR
LAMP
LAMP
EJECTOR
LAMP SOCKET
TERMINAL
ASSEMBLY
CONDENSER
LENS
HEAT ABSORBING
GLASS
A091_0018CCA
A091_0018CA
Warning
Dangerous Voltage
[1] Disconnect the main power.
Important
The EXTRA BRIGHT LAMP MODULE does not have a
HEAT ABSORBING GLASS and has a LABEL on the
LAMP DOOR.
[2] Remove the LAMP MODULE.
[3] Remove the PROJECTION LAMP from the LAMP
MODULE.
[4] Remove the SCREW from the LAMP DOOR
PLATE ASSEMBLY.
[5] Release the 2 TABS on the bottom side of the
LAMP MODULE next to the LAMP MODULE
DOOR.
[6] Remove the LAMP DOOR PLATE ASSEMBLY.
Caution
Remove the CONDENSER LENS and HEAT
ABSORBING GLASS and set the parts on a clean
cloth. Do not set on a cold surface; this will cause
damage to the parts.
[7] Remove the LAMP EJECTOR.
[8] Remove the LAMP SOCKET TERMINAL
ASSEMBLY.
18NOV97 – SM5440-1