Replacing Projection Lamp And Cleaning Projection Lens - Kodak pagent 250s User Manual

Replacing Projection
lamp and Cleaning
Projection lens
Projection Lamp: Loosen the lamphouse
cover screw and lift off the lamphouse
cover. (See Figures lland12.)
WARNING: Projection lamps get
very hot in use. Make sure the
lamp is cool before you handle it.
Cooling can be accelerated by
running the projector without film
(with the lamp off).
To remove the LAMP,grasp it just in front
of the LAMPSOCKET a nd pull upward to
release the lower rim from the two
retaining hooks at the front; lower the
lamp from the RETAINING SPRING, b ut do
not unhook the spring. Then pull the
socket from the back of the lamp.
To insert the new lamp, reverse the
procedure given above. Be certain that
the socket is pushed completely onto
the connecting pins at the back of the
lamp and that the rim of the lamp is fully
seated on both of the retaining hooks on
the mounting plate. Avoid touching the
small bulb inside the lamp reflector.
If it is touched accidentally, clean it
with alcohol and a clean cloth.
It is recommended that a SPARE
PROJECTION L AMPbe carried in the
projector lamphouse at all times.
Cleaning Lens: The projection lens
should be cleaned with care. Remove
the projection lens by drawing it out of
the lens holder. With a soft, lintless
cloth or KODAKLens Cleaning Paper,
carefully wipe the front and rear lens
surfaces. Do not use a wet cloth; if
moisture is required, breathe on the
lens or use a drop of KODAKLens
Cleaner.
WARNING: The use of treated
papers or cloths can harm the
LUMENIZED surface of the lens.
LAMPHOUSE COVER
FIGURE 11
SPARE LAMP HOLDER
SPARE
LAMP
FIGURE 12
SCREW
LAMP CONTROL
LAMP
15