Hardware Health Event Monitoring Screen - ASROCK NF6-GLAN User Manual

[Enabled] - Enables support for legacy USB.
[Auto] - Enables legacy support if USB devices are connected.
[Disabled] - USB devices are not allowed to use under legacy OS and
BIOS setup when [Disabled] is selected. If you have USB compatibility
issue, it is recommended to select [Disabled] to enter OS.
[BIOS Setup Only] - USB devices are allowed to use only under BIOS
setup and Windows / Linux OS.
3.4 3.4

Hardware Health Event Monitoring Screen

Hardware Health Event Monitoring Screen
3.4 3.4 3.4 Hardware Health Event Monitoring Screen Hardware Health Event Monitoring Screen Hardware Health Event Monitoring Screen
In this section, it allows you to monitor the status of the hardware on your system,
including the parameters of the CPU temperature, motherboard temperature, CPU fan
speed, chassis fan speed, and the critical voltage.
Main Advanced
Hardware Health Event Monitoring
CPU Temperature
M / B Temperature
CPU Fan Speed
Chassis Fan Speed
Vcore
+ 3.30V
+ 5.00V
+ 12.00V
CPU Quiet Fan
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
CPU Quiet Fan
This item allows you to control the CPU fan speed and fan noise. If you set
this option as [Disabled], the CPU fan will operate in full speed. If you set
this option as [Enabled], you will find the items "Target CPU Temperature"
and "Target Fan Speed" appear to allow you adjusting them. The default
value is [Disabled]. You are allowed to enable this function only when you
install 4-pin CPU fan.
Target CPU Temperature
The target temperature will be between 45 C/113 F and 65 C/149 F.
The default value is [50 C/122 F].
Target Fan Speed
Use this option to set the target fan speed. You can freely adjust the
target fan speed according to the target CPU temperature that you
choose. The default value is [Fast]. Configuration options: [Fast], [Middle]
and [Slow].
BIOS SETUP UTILITY
Boot Security
H/W Monitor
: 37 C / 98 F
: 31 C / 87 F
: 2833 RPM
: N / A
: 1.532 V
: 3.129 V
: 4.877 V
Select Screen
: 11.741 V
Select Item
F1 General Help
[Disabled]
F9 Load Defaults
F10 Save and Exit
ESC Exit
4 5 4 5 4 5 4 5 4 5
Exit