ASROCK NF6-GLAN User Manual page 35

Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is rec-
ommended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Frequency
Processor Voltage
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for system stability, it is not recommended to ad-
just the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for safety and system stability, it is not recom-
mended to adjust the value of this item.
Processor Target Frequency
This option appears only when you adopt Phenom CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for system stability, it is not recommended to ad-
just the value of this item.
North Bridge Target Frequency
This option appears only when you adopt Phenom CPU. This item will show
when "Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be
hidden. The range of the value depends on the CPU you adopt on this
motherboard. However, for safety and system stability, it is not recom-
mended to adjust the value of this item.
If AUTO, multiplier and
[Disabled]
voltage will be left at the
[Auto]
rated frequency/voltage. If
[200]
Manual, multiplier and
[100]
voltage will be set based
[Enabled]
on User Selection in Setup.
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled]
Select Screen Select Screen
[Disabled]
Select Item Select Item
+- +- Change Option Change Option
x25.0 5000 MHz
F1 F1 General Help General Help
1.350 V
F9 F9 Load Defaults Load Defaults
[Manual]
[x8] F10 F10 Save and Exit Save and Exit
[1.500V] ESC ESC Exit Exit
3 5 3 5 3 5 3 5 3 5