ASROCK K8NF6G-VSTA - V1.2 User Manual page 19

USB 2.0 Headers
(9-pin USB6_7)
(see p.10 No. 9)
(9-pin USB4_5)
(see p.10 No. 10)
Infrared Module Header
(5-pin IR1)
(see p.10 No. 14)
Internal Audio Connectors
(4-pin CD1)
(CD1: see p.10 No. 24)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.10, No. 20)
1. High Definition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
Besides four default USB 2.0
USB_PWR
ports on the I/O panel, there are
P-7
P+7
GND
two USB 2.0 headers on this
DUMMY
motherboard. Each USB 2.0
1
header can support two USB
GND
P+6
P-6
2.0 ports.
USB_PWR
USB_PWR
P-5
P+5
GND
DUMMY
1
GND
P+4
P-4
USB_PWR
This header supports an
IRTX
+5VSB
optional wireless transmitting
DUMMY
and receiving infrared module.
1
GND
IRRX
This connector allows you
to receive stereo audio input
CD-L
GND
from sound sources such as
GND
CD-R
a CD-ROM, DVD-ROM, TV
CD1
tuner card, or MPEG card.
This is an interface for the front
GND
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
1 9 1 9 1 9 1 9 1 9