Table of Contents
Advertisement
Primary Graphics Adapter
This item will switch the PCI Bus scanning order while searching for video
card. It allows you to select the type of Primary VGA in case of multiple
video controllers.
AGP Aperture Size
It refers to a section of the PCI memory address range used for graphics
memory. It is recommended to leave this field at the default value unless the
installed AGP card's specifications requires other sizes.
AGP Mode
The default value of this feature is set to [Auto]. If you install an 8X-AGP
card on this motherboard, you may select [Auto], [8X] or [4X] as the AGP
mode. If the installed AGP card is a 4X-AGP card, then you may set the AGP
mode as [Auto], [4X], [2X], or [1X].
AGP Fast Write
This allows you to enable or disable the feature of AGP fast write protocol
support.
IDE Driving Strength
Select [Normal] or [Strong] for IDE driving strength.
PCI Delay Transaction
Enable PCI Delay Transaction feature will free the PCI Bus when the CPU is
accessing 8-bit ISA cards. Disable this feature when using ISA cards that
are not PCI 2.1 compliant.
OnBoard LAN
This allows you to enable or disable the onboard LAN feature.
OnBoard AC'97 Audio
Select [Enabled] or [Disabled] for the onboard AC'97 Audio feature.
HT Width
You may set the HyperTransport width as [8 bit], [16 bit] or [Auto]. The
default value is [Auto].
HT Speed
You may set the HyperTransport speed as [Auto], [200 MHz], [400 MHz],
[600 MHz], or [800 MHz]. The default value is [Auto].
3 1
3 1
3 1
3 1
3 1
Advertisement
Table of Contents
