Table of Contents
Advertisement
CPU Host Frequency
While entering setup, BIOS auto detects the present CPU host frequency of
this motherboard. The actual CPU host frequency will show in the following
item.
Spread Spectrum
This item should always be [Disabled] for better system stability.
Cool 'n' Quiet
Use this item to enable or disable AMD's Cool 'n' Quiet
Processor Maximum Multiplier
It will display Processor Maximum Multiplier for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Multiplier and Processor Voltage. However, it is recom-
mended to keep the default value for system stability.
Advanced
CPU Configuration
CPU Host Frequency
Actual Frequency (MHz)
Spread Spectrum
Cool' n' Quiet
Processor Maximum Multiplier
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Multiplier
Processor Voltage
Memory Clock
Flexibility Option
Bank Interleaving
Burst Length
CAS Latency (CL)
TRCD
MA Timing
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Multiplier
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. You may set the value from [x4] up to [x25] but
no higher than the value of "Processor Maximum Multiplier". For example, if
the value of "Processor Maximum Multiplier" is [x11], the actual value of
multiplier will be [x11] even if you set this item to a value higher than [x11].
However, for system stability, it is not recommended to adjust the value of
this item.
Processor Voltage
This item will show when "Multiplier/Voltage Change" is set to [Manual];
otherwise, it will be hidden. You may set the value from [1.550V] down to
[0.800V]. However, for safety and system stability, it is not recommended
to adjust the value of this item.
BIOS SETUP UTILITY
[Auto]
[200]
[Disabled]
[Enabled]
x11
1.550 V
[Manual]
[x8]
[1.500V]
[Auto]
[Disabled]
[Auto]
[8 Beats]
[Auto]
[Auto]
[2T]
2 7
2 7
2 7
2 7
2 7
TM
technology.
If AUTO, FID/VID will
be left at the rated
frequency/voltage. If
Manual, FID/VID will
be set based on User
Selection in Setup.
Select Screen
Select Screen
Select Item
Select Item
+-
+-
Change Option
Change Option
F1
F1
General Help
General Help
F9
F9
Load Defaults
Load Defaults
F10
F10
Save and Exit
Save and Exit
ESC
ESC
Exit
Exit
Advertisement
Table of Contents
