Page 1
ASSEMBLY INSTRUCTION HUGHES BUFFET ITEM CODE 79458/79441 Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please refer to your receipt...
PRE-ASSEMBLY PREPARATION Before you start: 1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2.Take care when li�ing. Product should be assembled as near as possible to the point of 3.Ensure that you have all required contents for complete assembly 4.Always read the assembly instruc�ons carefully before beginning assembly.
Page 5
PARTS LIST ITEM QTY NO. ITEM 1 PC TOP PANEL 1 PC LEFT DOOR PANEL 1 PC LEFT SIDE PANEL 1 PC RIGHT DOOR PANEL 1 PC 1 PC RIGHT SIDE PANEL LEFT DOOR PANEL 1 PC BOTTOM PANEL 2 PCS SIDE ARC PANEL 4 PCS BACK PANEL...
Page 14
STEP 17: Assemble these four holes first, adjust the door and ensure it is level, then tighten all screws. How to adjust the door and ensure it is level, please see the below information. INFORMATION...
Page 16
ASSEMBLY IS COMPLETE CAUTION:Always Lift Your Furniture When Moving /Relocating - Do Not Drag. Dragging Can Cause The Legs To Bend/Break.
Page 17
SAFETY BRACKETS INSTRUCTIONS 1. Attach the strap to the furniture frame with the small screw and washer. 2. Move the furniture to its final position.Attach the strap to the wall with the large screw and washer. If mounting into brick or masonry you will need to acquire wall anchors.
Page 18
To protect your furniture, we suggest the following: • Avoid placing your furniture in direct sunlight. • Do not place furniture directly under windows. • Do not place sharp materials (knife, fork, etc.) directly onto your furniture as sharp material may scrape and damage the finish.
Need help?
Do you have a question about the HUGHES 79458 and is the answer not in the manual?
Questions and answers