Using The Headphone Section - Radial Engineering Nuance select User Manual

USING THE HEADPHONE SECTION

The Nuance Select features two built in
headphone amplifiers, each with their own
independent level controls and source select
switches to provide added flexibility for
recording overdubs in the control room.
The two 1/4" headphone outputs are located
on the front panel of the Nuance, with the left
output corresponding to the left set of controls
on the top panel.
The SRC 1/2 switch selects which input source
feeds each set of headphones.
When this switch is unlit, the headphone output associated with it will be
monitoring Source 1. When the switch is illuminated, Source 2 will feed
that headphone output.
These individual controls allow for easy overdub recording with an artist
in the control room. For example, the engineer can monitor the main
mix on a pair of headphones set to Source 1, while the artist can hear
their own cue mix while tracking by setting their input select switch to
monitor Source 2.
Two sets of headphones can be independently paired with either input source
We recommend turning the headphone level all the way down before
beginning playback to protect your hearing. Then activate the PHONES
switch to turn on both headphone outputs and slowly increase the level
using the control knob.
Whenever you aren't listening through headphones, you can use the
PHONES switch to mute the headphone outputs and avoid having to
readjust the headphone level controls.
8
Radial Engineering Ltd. Nuance Select™