3.4.2
3.4.2 Chipset Configuration
3.4.2
Chipset Configuration
Chipset Configuration
Chipset Configuration
3.4.2
3.4.2
Chipset Configuration
Advanced
Chipset Configuration
Memory Remap Feature
DRAM Frequency
Flexibility Option
Standard Memory Info : 5-5-5-15-36-5-3-3-3
DRAM tCL
DRAM tRCD
DRAM tRP
DRAM tRAS
DRAM tRFC
DRAM tWR
DRAM tWTR
DRAM tRRD
DRAM tRTP
Advanced Memory Info : 18-54-4-0-0-0
DRAM CH0 RCOMP ODT
DRAM CH1 RCOMP ODT
DRAM CH0 tRD
DRAM CH1 tRD
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Memory Remap Feature
Use this item to enable or disable memory remap feature. Configuration
options: [Enabled] and [Disabled]. The default value is [Disabled].
DRAM Frequency
If [Auto] is selected, the motherboard will detect the memory module(s)
inserted and assigns appropriate frequency automatically. You may select
[333MHz (DDR2 667)], [400MHz (DDR2 800)] or [533MHz (DDR2 1066)].
The configuration options depend on the CPU and memory module you
adopt on this motherboard. Please refer to page 8 for the CPU FSB
frequency and its corresponding memory support frequency.
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
DRAM tCL
Use this item to adjust the means of memory accessing. Min: 3. Max: 7. The
default value is [Auto].
DRAM tRCD
This controls the number of DRAM clocks for TRCD. Min: 3. Max: 10. The
default value is [Auto].
DRAM tRP
This controls the number of DRAM clocks for TRP. Min: 3. Max: 10. The
default value is [Auto].
DRAM tRAS
This controls the number of DRAM clocks for TRAS. Min: 9. Max: 24. The
default value is [Auto].
DRAM tRFC
This controls the number of DRAM clocks for TRFC. Min: 15. Max: 78. The
default value is [Auto].
3 2
3 2
3 2
3 2
3 2
BIOS SETUP UTILITY
ENABLE: Allow
[Disabled]
remapping of
[Auto]
overlapped PCI memory
[Disabled]
above the total
physical memory.
[Auto]
[Auto]
DISABLE: Do not allow
[Auto]
remapping of memory.
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
+ -
F1
[Auto]
F9
F10
[Auto]
[Auto]
ESC
[Auto]
[Auto]
Select Screen
Select Item
Change Option
General Help
Load Defaults
Save and Exit
Exit