Cpu Configuration - ASROCK G41M-S User Manual

3.4.1 CPU Configuration

3.4.1 3.4.1 CPU Configuration CPU Configuration CPU Configuration
3.4.1 3.4.1 CPU Configuration
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Boot Failure Guard
Spread Spectrum
Ratio Status
Ratio Actual Value
Ratio CMOS Setting
Intel (R) Virtualization tech.
CPU Thermal Throttling
No-Excute Memory Protection
On-Demand Clock Modulation
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Cnfiguration
options: [Auto], [Manual] and [Optimized].
CPU Frequency (MHz)
Use this option to adjust CPU frequency.
PCIE Frequency (MHz)
Use this option to adjust PCIE frequency.
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
Spread Spectrum
This item should always be [Auto] for better system stability.
Ratio Status
This is a read-only item, which displays whether the ratio status of this
motherboard is "Locked" or "Unlocked". If it shows "Unlocked", you will find
an item Ratio CMOS Setting appears to allow you changing the ratio
value of this motherboard.
Ratio Actual Value
This is a read-only item, which displays the ratio actual value of this
motherboard.
Ratio CMOS Setting
If the ratio status is unlocked, you will find this item appear to allow you
changing the ratio value of this motherboard. If the CPU you adopt supports
EIST (Intel (R) SpeedStep(tm) tech.), and you plan to adjust the ratio value,
please disable the option " Intel (R) SpeedStep(tm) tech." in advance.
Enhance Halt State
All processors support the Halt State (C1). The C1 state is supported
through the native processor instructions HLT and MWAIT and requires no
hardware support from the chipset. In the C1 power state, the processor
maintains the context of the system caches.
3 0 3 0 3 0
3 0 3 0
BIOS SETUP UTILITY
Select the over clock
mode.
[Auto]
[200]
[100]
[Enabled]
[Auto]
Unlocked (Min: 12, Max: 14)
14
[14]
[Enabled]
[Enabled]
+- +-
[Disabled]
F1 F1
[Auto]
F9 F9
F10 F10
ESC ESC
Select Screen Select Screen
Select Item Select Item
Change Option Change Option
General Help General Help
Load Defaults Load Defaults
Save and Exit Save and Exit
Exit Exit