ASROCK ALIVEXFIRE-ESATA2 User Manual page 20

Step 1. Remove PCIE Switch card from PCIE2/PCIE SWITCH slot if one is installed.
Step 2. Connect to the system power supply. Please connect a hard disk power
connector to SLI/XFIRE Power connector on this motherboard.
It is recommended to use 500-Watt power supply or greater
to perform the benefit of CrossFire
X850XT, X1900 and X1950 series.
Step 3. Install the standard Radeon (CrossFire
PCIE SWITCH slot. For the proper installation procedures, please refer to
section "Expansion Slots".
Standard Radeon
(CrossFire
TM
graphics card
Step 4. Install the Radeon CrossFire
proper installation procedures, please refer to section "Expansion Slots".
Standard Radeon
(CrossFire Ready)
TM
graphics card
Radeon CrossFire
TM
Edition graphics card
1. You are allowed to install two CrossFire
may use one CrossFire
(CrossFire Ready) graphics card from the same series.
TM
2. For ATI Radeon X1300, X1600, X1650 and X1950Pro series, there are no CrossFire
TM
Edition graphics cards. You can still install two regular graphics cards from the same
series on PCIE2/PCIE SWITCH slot and PCIE3 slot to support CrossFire
please connect the monitor cable to the graphics card on PCIE3 slot.
Step 5. Correctly connect the DVI-DMS cable to the monitor connector and two
graphics cards that you install. (If you install two standard Radeon
(CrossFire Ready) graphics cards to this motherboard, please skip this
TM
step.)
DVI-DMS cable
feature for Radeon
TM
Ready) graphics card to PCIE2/
TM
Ready)
Edition graphics card to PCIE3 slot. For the
TM
Edition graphics cards to both slots, or you
TM
Edition graphics cards and a compatible standard Radeon
TM
DMS connector
2 0 2 0 2 0 2 0 2 0
TM
. Besides,
TM
DVI connector