Onboard Headers And Connectors - ASROCK AD425PV - V1.0 User Manual

2.6 Onboard Headers and Connectors

2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATAII_1: see p.10, No. 9)
(SATAII_2: see p.10, No. 8)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.10 No. 10)
(9-pin USB4_5)
(see p.10 No. 11)
Internal Audio Connector
(4-pin CD1)
(CD1: see p.10 No. 16)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.10 No. 17)
1 6 1 6 1 6
1 6 1 6
These Serial ATAII (SATAII)
SATAII_2
connectors support SATAII
or SATA hard disk for internal
storage devices. The current
SATAII_1
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA /
SATAII hard disk or the SATAII
connector on the motherboard.
USB_PWR
Besides four default USB 2.0
P-7
P+7
ports on the I/O panel, there are
GND
DUMMY
two USB 2.0 headers on this
1
motherboard. Each USB 2.0
GND
P+6
header can support two USB
P-6
USB_PWR
2.0 ports.
USB_PWR
P-5
P+5
GND
DUMMY
1
GND
P+4
P-4
USB_PWR
This connector allows you
CD-L
to receive stereo audio input
GND
GND
from sound sources such as
CD-R
a CD-ROM, DVD-ROM, TV
CD1
tuner card, or MPEG card.
GND
This is an interface for front
PRESENCE#
MIC_RET
panel audio cable that allows
OUT_RET
convenient connection and
1
control of audio devices.
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L