The EASTWOOD NO-WELD PANEL REPAIR KIT is designed to make permanent patch panel repairs in steel and aluminum when a welder is not available. Repairs with patch panels or custom fabricated panels utilizing our panel adhesive can be done with structural integrity far superior to rivets themselves.
Page 3
Adjust patch panel by carefully trimming to fit level and flush all around flange area (Figs E & F). NOTE: PATCH PANEL SHOULD BE SAME GAUGE AS ORIGINAL PANEL. Fig. D To order parts and supplies: 800.345.1178 >> eastwood.com...
Page 4
After dimpling holes in small panels, you may have to straighten the edges. This can be done with hammer and dolly in the original panel, and a hammer and anvil on the patch panel (Fig I). Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
Page 5
NOTE: SOAK THE BLIND HOLDERS IN LACQUER THINNER BEFORE ADHESIVE HAS A CHANCE TO SET UP, FAILURE TO DO THIS WILL RENDER THEM INOPERABLE. To order parts and supplies: 800.345.1178 >> eastwood.com...
Page 6
TECH TIP: Spray backside of patch panels with Eastwood Zinc-Rich Galvanize (#13242Z) to protect from corrosion. SMC and fiberglass can be bonded with the use of the panel adhesive alone. Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
Page 7
To order parts and supplies: 800.345.1178 >> eastwood.com...
No-Weld Panel Adhesive Replacement If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/31102manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178...
Need help?
Do you have a question about the 31102 and is the answer not in the manual?
Questions and answers