Starting The Sensorsupportsoftware - Omron SENSOR SUPPORT SOFTWARE S3 Operation Manual

Starting the SensorSupportSoftware

5-1 Starting the SensorSupportSoftware
16
• Start the program by double-clicking the SensorSupportSoftware pro-
gram icon in the OMRON\SensorSupportSoftware program group.
After the program has started, the SensorSupportSoftware runs an auto-
matic interface check, including sensor selection and detection.
In this example, a sensor has been found at the serial COM1 interface. This
sensor's setting is read and the Sensor selection window is closed.
The Sensor selection window stays open if several sensors are
detected. In this window, the sensors found can be selected for setting
by clicking the relevant Sensor Selection button.
Sensor Selection
The sensors found are selected for setting by clicking the Sensor
Selection button.
Repeat
Sensor detection can be repeated by clicking the Repeat button.
No sensor detected
Indicates that no sensor is connected to the relevant interface.
Not available
Indicates that the relevant interface is not installed or is already
occupied.
Section 5-1