Connecting A Printer; How To Connect - Omron NT11 - 01-2004 User Manual

Connecting a Printer

2-8

Connecting a Printer

2-8-1

How to Connect

!Caution If the connection cable is connected or disconnected while the power of the
Setting Switches on a CQM1H Serial Communications Board
Set the switches on a CQM1H Serial Communications Board as follows.
Wire selection (WIRE): Set to 4 (4-wire, for RS-422A)
Terminator (TERM): Set to ON for termination ON.
Daily reports and display histories can be printed onto a printer connected to
the NT11.
Connect the printer to the NT11 with a Centronics cable. The length of the
cable should not exceed 3 meters.
printer is on, the NT11 may malfunction. Make sure to turn off the power of the
printer before connecting or disconnecting the connection cable.
• Recommended printer
EPSON ESC/P Printer (25-pin)
If using other printer, such printer should conform to ESC/P 24-J81, which is
the printer control standard of Epson.
Serial Communications Board
(Inner Board slot 1)
Terminator Switch (TERM)
Set to ON (right side).
Wire Selection Switch (WIRE)
Set to 4 (right side).
Section 2-8
EPSON ESC/P
Printer (25-pin)
57