Omron NS - REV 12 Setup Manual page 45

NS12/NS10 Rear Panel Switches
Main Circuit DC
Power Input Terminal Block Cover
Input Terminals
Covers the power input terminal block.
Used to connect
the power supply.
FG Terminal
Used to prevent
malfunctions due to
noise interference.
USB Host Connector
Used to connect to printers. It is a
USB Type A connector.
Refer to 3-5-1 Connecting to a
Printer Compatible with ESC/P
Raster or BJ Raster.
Precautions
for Safe Use
Expansion Interface Connector
Used to mount the Video Input
Unit or the Controller Link
Interface Unit.
Serial Port B Connector
Used to connect the host, CX-
Designer, and Bar Code Reader.
Uses an RS-232C 9-pin
connector.
USB Slave Connector
This is a USB Type B connector. It can be used to connect to the CX-Designer.
Refer to 3-3-2 Connecting via USB.
A PictBridge-compatible printer can also be connected to the NS12-V2 or NS10-V2.
(Refer to 3-5-2 Connecting a PictBridge-compatible Printer.)
Confirm system safety before turning the power ON/OFF or restarting. Other-
wise the system may operate unpredictably.
2-2 Part Names and Functions
Memory Card Connector
Used to connect the
memory card for storing
and transmitting screen
data, log data, and system
programs.
DIP Switch
Used to set the settings for
transmitting data using the
Memory Card.
Reset Switch
Used to initialize the PT.
The status of screen data,
other registered data, and
the system menu, however,
will not change.
Battery Cover
The battery is installed
underneath the cover.
Serial Port A Connector
Used to connect the host, CX-Designer, and
Bar Code Reader. Uses an RS-232C 9-pin
connector.
Ethernet Connector
Used to connect the Ethernet cable. Uses a
10Base-T/100Base-T 8-pin modular plug.
2-11