Linksys SPA-2102 Quick Start Manual

Knowledge Base > Handsets and Device Provisioning > Handsets >
Cisco ATA SPA-2102
Mike Johnstone - 2024-05-30 -
Cisco ATA SPA-2102
We recommend first that you upgrade your Linksys SPA-2102 to the latest firmware version
from Cisco.
Quick Guide
The Linksys SPA2102 is a low-cost Analogue Telephone Adapter that offers 2 ports allowing
you to connect 2 phone lines to SIPcity. The SPA2102 (unlike the PAP2T) also supports T.38
for reliable fax transmission over IP, so you can also connect a fax machine to this service.
First, you should click on 'Admin Login' and then 'Advanced' to get access to all of the ATA's
settings. While there are a LOT of settings you will only need to change the items listed
below. Leave everything else as default.
How to configure
1. Get access to your SPA-2102 web interface
Plug an Ethernet cable from the Internet port into your router
Plug an Ethernet cable into the yellow LAN (Ethernet) port and your PC / MAC
Dial ****110#
Listen to IP Address which is read back to you
Enter IP Address into your web browser (For example. http://192.168.1.10)
You should now see the Linksys SPA-2102 Web Interface.
2. Line pages
Line Enable = yes
NAT Settings:
NAT Mapping Enable: yes
Handsets
Cisco ATA SPA-2102