Linksys SPA2102 Installation Manual

The Linksys SPA2102 adapter from Yak will include the following: the Linksys SPA2102 analogue telephone adapter (ATA),
an Ethernet cable and a power adapter.
You will need an analogue phone, a cable or DSL modem, high speed Internet service and an Ethernet cable that should
currently connect your computer to your modem.
A) ATA CONNECTED TO A MODEM – RECOMMENDED INSTALLATION
PHONE1 PHONE 2
Telephone Computer
In this configuration, if DSL is being used it is highly recommended to use the modem in bridge mode and use the ATA for
PPPoE authentication. Configuration of the ATA in that way is described in section C.
1. Disconnect the power from your cable or DSL modem and computer.
2. Connect one end of an Ethernet cable into the INTERNET port on the phone adapter (ATA) and the other end into
your Cable/DSL modem.
3. Connect another Ethernet cable from your computer or router WAN/INTERNET port to the ETHERNET port on
the phone adapter (ATA). If you are using a home router then connect your PC(s) to the free router ports using
separate Ethernet cables.
4. Connect your analogue telephone to the LINE 1 port of the ATA Phone Adapter.
5. Connect the power to the Cable/DSL modem and power it up.
6. Plug the power adapter into the phone adapter (ATA).
7. Wait about two minutes for the Cable/DSL modem to boot up and for the status indicators to be lit. The Linksys
ATA Phone Adapter's red status light will blink in sequence until it has fully connected to the Yak Digital Phone
service. Do not interrupt the configuration process by unplugging the power or lifting the receiver on your phone
during the startup process. The Power, Ethernet and Phone LEDs will be solidly lit when the phone adapter is
ready for use.
Over 10 years of Canadian Customer Service
Installation Guide For
The Linksys SPA2102
ETHERNET INTERNET
POWER
DSL/Cable
Modem
Power
Adapter
1-866-736-1303 yak.ca