Omron EJ1G Datasheet page 6

EJ1G-HFU
■ Ratings
Power supply voltage
Operating voltage range
Power consumption
Auxiliary outputs Outputs
(See note 1.)
Transistor outputs
Event inputs Inputs
(See note 2.)
Inputs with contacts
Inputs without contacts
Programless Programless downloading
connection (EJ1G writes data to a PLC)
Programless uploading
(EJ1G reads data from a
PLC)
Applicable PLCs
Control method
Other functions
Ambient temperature range
Ambient humidity range
Note: 1. Auxiliary outputs can be allocated using auxiliary output allocations.
2. Allocated using the digital input allocation function.
■ Characteristics
Insulation resistance
Dielectric strength
Vibration resistance
Shock resistance
Weight
Degree of protection
Memory protection
Standards Approved standards
Conformed standards
EMC Directive
6
Modular Temperature Controller for Gradient Temperature Control
24 VDC
85% to 110% of rated voltage
2 W max. (at maximum load)
4
Max. operating voltage: 30 VDC, Max. load current: 50 mA
4
ON: 1 k Ω max., OFF: 100 k Ω min.
ON: Residual voltage of 1.5 V max., OFF: Leakage current of 0.1 mA max.
Short-circuit current: Approx. 4 mA (per contact)
Number of parameters that can be set: 300
Number of parameters that can be set: 300
OMRON: SYSMAC CS/CJ Series, Mitsubishi Electric: MELSEC-Q/QnAS Series
2-PID control (with autotuning), gradient temperature control (with gradient tuning function)
2-point input shift, SP ramp, manual manipulated variable, manipulated variable limiter,
interference overshoot adjustment, heater burnout alarm, RUN/STOP, banks, I/O allocations,
etc.
Operating: − 10 ° C to 55 ° C
− 25 ° C to 65 ° C (with no icing or condensation)
Storage:
Operating: 25% to 85% (with no condensation)
20 M Ω min. (at 500 VDC)
600 VAC, 50/60 Hz for 1 min between current-carrying terminals of different polarity
2
10 to 55 Hz, 20 m/s for 2 hours each in X, Y, and Z directions
2
150 m/s max., 3 times each in 6 directions
160 g
Rear case: IP20, Terminal section: IP00
EEPROM (non-volatile memory) (number of writes: 100,000)
UL61010C-1, CSA C22.2 No.1010-1
EN61010-1 (IEC61010-1): Pollution level 2, overvoltage category II
Refer to page 3.
EJ1G