Builder For Ns; Network Configuration - Omron CX-ONE V1.1 - SETUP MANUAL 11-2005 Setup Manual

Support Software in CX-One
1-3-2 Starting Support Software in CX-One
Start with Settings
Inherited
CX-Protocol
Select CX-Protocol.
Start with Settings
Inherited
CX-Position
Start with Settings
Inherited
CX-Motion-NCF
Start with Settings
Inherited
CX-Motion
Start with Settings
Inherited
CX-Process Tool
Faceplate Auto-

Builder for NS

Start with Settings
Inherited
CX-Profibus
Start with Settings
Inherited
CX-FLnet
Select Tools - Network Settings.
Switch Box Utility
Select Tools - Switch Box Utility.
Support Software in CX-One can be started from the I/O tables in the CX-Pro-
grammer, from the Network Configuration Window in the CX-Integrator, or
from the Tools Menus as shown in the following diagram. This is called the
Specialized Support Tool startup function and it is enabled when the CX-Pro-
grammer and other Support Software is installed from the CX-One.
CX-Programmer
I/O Table Window
CS/CJ-series CPU Unit
CPU Rack
Ethernet Unit
(CS1W/CJ1W-ETN@@)
Controller Link Unit
(CS1W/CJ1W-CLK@@)
SYSMAC LINK Unit
(CS1W-SLK@@)
DeviceNet Unit
(CS1W/CJ1W-DRM@@)
Serial Communications
Board/Unit
(CS1W-SCB@@)
(CS1W/CJ1W-SCU@@)
Position Control Unit
(CS1W/CJ1W-NC@@@)
Position Control Unit with MECHA-
TROLINK-II Communications
(CJ1W-NCF@@)
Motion Control Unit
(CS1W-MC@@@)
Loop Control Unit/Board
(CS1W-LC001/LCB@@)
Loop Control CPU Unit
(CJ1G-CPU@@P)
Process Control CPU Unit
(CS1D-CPU@@P)
PROFIBUS-DP
Master Unit
(CJ1W-PRM@@)
FL-net Unit
(CS1W/CJ1W-FLN@@)
CX-One Startup Diagram
Network Configuration Window
Start with Settings
Inherited
CS/CJ-series CPU Unit
Start with Settings
Inherited
Start with Settings
Ethernet, Controller Link, or SYSMAC LINK
Inherited
DeviceNet
NS-series PC (-V1)
Start with Settings
Inherited
Select CX-Integrator.
NT Link
E5@@ Temperature
Controller
CompoWay/F
Select Tools - Start Routing Table from the menu bar
or right-click Network Communications Unit in Online
Connection Information Window and select Start Rout-
ing Table from the pop-up menu.
Select Tools - Start Data Link from the menu bar or
right-click Controller Link or SYSMAC LINK Unit in On-
line Connection Information Window and select Start
Data Link from the pop-up menu.
Section 1-3
CX-Integrator
Started with Settings
Inherited
CX-Drive
Start with Settings
Inherited
CX-Designer
Start with Settings
Inherited
CX-Thermo
Routing Table
Component
Data Link
Component
7