System Board Components; Installing The System Board - Dell OptiPlex 9010 Small Form Factor Owner's Manual

System Board Components

The following image displays the system board layout.
1. RTC reset jumper
3. power connector
5. system fan connector
7. power switch connector
9. system fan connector
11. internal speaker connector
13. SATA connectors
15. coin-cell battery

Installing the System Board

1. Align the system board to the port connectors at the rear of the chassis and place the system board in the chassis.
2. Tighten the screws that secure the system board to the chassis.
3. Tighten the hex screw clockwise.
4. Re-connect all the cables to the system board.
5. Install the:
a. heat sink
b. expansion card
c. drive cage
d. front bezel
e. cover
38
2. intrusion-switch connector
4. processor
6. password jumper
8. memory module connectors
10. system power connector
12. PCI Express x16 connectors
14. front-USB connector