Installing The Power-Switch Cable; Removing The Input/Output (I/O) Panel - Dell OptiPlex 9010 Small Form Factor Owner's Manual

4. Press in the retention clips and slide the power-switch cable out through the front of the computer.

Installing the Power-Switch Cable

1. Slide the power-switch cable in through the front of the computer.
2. Secure the power-switch cable to the chassis.
3. Thread the power-switch cable into the chassis clip.
4. Connect the power-switch cable to the system board.
5. Install the:
a. drive cage
b. front bezel
c. cover
6. Follow the procedures in

Removing the Input/Output (I/O) Panel

1. Follow the procedures in
2. Remove the:
a. cover
b. front bezel
26
After Working Inside Your Computer .
Before Working Inside Your Computer .