Table of Contents
Advertisement
5.
Rotate the drive cage upward using the handle and lift the drive cage free off the chassis.
Installing the Drive Cage
1.
Place the drive cage on the edge of the computer to allow access to the cable connectors on the hard drive.
2.
Connect the data cable and power cable to the back of the hard drive.
3.
Flip over the drive cage and insert it into the chassis. The drive cage tabs are secured by the slots in the chassis.
4.
Slide the drive-cage handle toward the front of the computer into the locked position.
5.
Connect the data cable and power cable to the back of the optical drive.
6.
Install the:
a. front bezel
b. cover
7.
Follow the procedures in
Removing the Optical Drive
1.
Follow the procedures in
2.
Remove the cover.
After Working Inside Your Computer .
Before Working Inside Your Computer .
13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 9010 Small Form Factor and is the answer not in the manual?