Technical Data; General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside XQ90 - MANUEL 3 Operation And Safety Notes

Technical Data

Q
Waxer / polisher
PARKSIDE XQ90-KH3013
Rated voltage:
Rated power:
no-load rotational speed:
Polishing disc:
Protection class:
Noise and vibration data:
Values determined in accordance with En 60745.
The sound pressure level (A-weighted) of the
device is typically 60 dB(A). Uncertainty K=3 dB.
The sound level while working can exceed 71 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
Uncertainty K = 1,5 m / s
WARNING! The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in En 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to under-
estimate the vibration load if the electrical power
tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Introduction / General safety advice for electrical power tools
230 - 240 V ~ , 50 Hz
90 W
n = 3300 min
-1
0
ø 250 mm
II /
&
= 2,6 m / s
2
2
XQ90
230 - 240 V~ · 50 Hz · 90 W
n 3300 min · ø 250 mm
-1
0
Date of manufacture: 03 / 2008
KH3013
Kompernaß GmbH · 44867 Bochum · Germany
www.kompernass.com
General safety advice for
electrical power tools
Read all the safety advice
WARNING!
and instructions!
Failure to observe the safety advice and instructions
may result in electric shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AnD InSTRUCTIOnS
In A SAFE PLACE FOR FUTURE REFEREnCE!

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
Do not work with the device
b)
in potentially explosive en-
vironments in which there are
inflammable liquids, gases or dusts.
Electrical power tools create sparks, which can
ignite dusts or fumes.
c) Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.
GB/IE/CY 7