Parkside PSBS 24 A1 CORDLESS HAMMER DRILL Operation And Safety Notes page 9

General safety advice for electrical power tools / Preparing for use
d)
½
to noise can cause hearing loss.
½
machine can lead to injuries.
½
Contact with a live electrical wire can
also make metal parts of the electrical tool live
and can lead to electric shock.
½
precaution is intended to prevent you from unin-
tentionally starting the device.
½
your battery has long working life.
½
there is the danger of overheating.
½
10 GB/IE/CY
Exposure
10
Losing control of the
This
In this way you will ensure
Otherwise
©
½
inserted tools or accessories other than those
recommended in the operating instructions
could lead to you suffering an injury.
©
electrical cables, gas or water pipes when you
are working with an electrical power tool.
Check a wall using a suitable detector before
you drill or cut slots.
©
©
Screw the additional handle
hand or the right-hand side of your appliance
depending on the way you work.
©
A battery pack that has been unused for a
while or never been charged must be charged
before reuse or first use. The battery pack requires
about 3 - 5 cycles before it can reach its full charge.
Charging takes about 90 minutes.
the mains socket before removing the battery pack
from the charger or inserting it into the charger. This
precaution is intended to prevent you from uninten-
tionally starting the device.
Push the coupler (see Fig. A) onto the recharge-
able battery pack
5
into the socket.
The red charge indicator LED
the charging process has started. The red light
goes out as soon as the battery pack
charged.
The use of
Ensure that you do not strike
10 onto the left-
Always pull the mains plug from
. Insert the mains plug
9
15 indicates that
9 is fully