Download
Share
Print this page
  1. Manuals
  2. Brands
  3. rako Manuals
  4. Dimmer
  5. WLED75CV1
  6. Instruction manual

rako WLED75CV1 Instruction Manual

Wired single channel constant voltage dimmer
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Instruction Manual
WLED75CV1
Wired Single Channel Constant Voltage Dimmer
2024
Version 2.2.0

Advertisement

loading
Need help?

Need help?

Do you have a question about the WLED75CV1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for rako WLED75CV1

Summary of Contents for rako WLED75CV1

  • Page 1 Instruction Manual WLED75CV1 Wired Single Channel Constant Voltage Dimmer 2024 Version 2.2.0...
  • Page 2 The WLED75CV1 is a single Channel constant voltage dimmer used in a Rako Wired network. The RJ11 port on the WLED75CV1 is used to connect to the Rako Wired network, if it is not connected to one of the RAK-LINKs RJ11 ports, a WK-CONNECT is required.
  • Page 3 Installation should only be carried out by a competent electrician. DO NOT CONNECT DIRECTLY TO THE MAINS SUPPLY. ● WLED75CV1 modules should be mounted in areas that are adequately ventilated, and dry. ● Modules should be mounted vertically, with the terminals at the bottom, or horizontally.
  • Page 4 Replace the covers. 4 Terminating the WK-CONNECT The WK-CONNECT is used to connect between the WLED75CV1 and the Rako Wired network. The WK-CONNECT must be terminated correctly otherwise the WLED75CV1 will not function. The termination requirements depend on the nature of the installation and the position of the WK-CONNECT within the system.
  • Page 5 5 Adding the WLED75CV1 into Rasoft Pro Once the WLED75CV1 has been installed and connected to the Rako Wired network, it needs to be assigned as a Device in Rasoft Pro. The following steps assume: A Project File has been created.
  • Page 6 Press and hold the clear button on the WLED75CV1 for 3-4 seconds until it starts to flash, ‘Device Found’ will appear in the software window. Select ‘Finish’. The Rako Wired network must be connected and powered to the WLED75CV1 for pairing to be successful.
  • Page 7 Star Wired systems are connected back to the RAK-STAR unit with individual runs of CAT5 or CAT6 cable, there can be multiple Devices on a single run, although the end of line must be set to ‘STAR’ at the end of line. WLED75CV1 Manual Version 2.2.0...
  • Page 8 A1.2 Radial Wiring Radial wiring connects two or more Devices together in a single continuous run, each end of line must have a ‘Term’ set on the termination jumpers. WLED75CV1 Manual Version 2.2.0...