Advertisement
Quick Links
Advertisement
Related Manuals for rako WLED150CV1
Summary of Contents for rako WLED150CV1
- Page 1 Instruction Manual WLED150CV1 Wired Single Channel Constant Voltage Dimmer 2024 Version 2.2.0...
- Page 2 The WLED150CV1 is a single Channel constant voltage dimmer used in a Rako Wired network. The RJ11 port on the WLED150CV1 is used to connect to the Rako Wired network, if it is not connected to one of the RAK-LINKs RJ11 ports, a WK-CONNECT is required.
- Page 3 Installation should only be carried out by a competent electrician. DO NOT CONNECT DIRECTLY TO THE MAINS SUPPLY. ● WLED150CV1 modules should be mounted in areas that are adequately ventilated, and dry. ● Modules should be mounted vertically, with the terminals at the bottom, or horizontally.
- Page 4 Replace the covers. 4 Terminating the WK-CONNECT The WK-CONNECT is used to connect between the WLED150CV1 and the Rako Wired network. The WK-CONNECT must be terminated correctly otherwise the WLED150CV1 will not function. The termination requirements depend on the nature of the installation and the position of the WK-CONNECT within the system.
- Page 5 5 Adding the WLED150CV1 into Rasoft Pro Once the WLED150CV1 has been installed and connected to the Rako Wired network, it needs to be assigned as a Device in Rasoft Pro. The following steps assume: A Project File has been created.
- Page 6 ‘Automatic Name’. Assign the WLED150CV1 a Room, and leave ‘Associate to new Channel’ blank. Press and hold the clear button on the WLED150CV1 for 3-4 seconds until it starts to flash, ‘Device Found’ will appear in the software window.
- Page 7 The Rako Wired network must be connected and powered to the WLED150CV1 for pairing to be successful. The WLED150CV1 has now been added as a Device, the Channel for the Device can be found by selecting the Room it was programmed to.
- Page 8 Star Wired systems are connected back to the RAK-STAR unit with individual runs of CAT5 or CAT6 cable, there can be multiple Devices on a single run, although the end of line must be set to ‘STAR’ at the end of line. WLED150CV1 Manual Version 2.2.0...
- Page 9 A1.2 Radial Wiring Radial wiring connects two or more Devices together in a single continuous run, each end of line must have a ‘Term’ set on the termination jumpers. WLED150CV1 Manual Version 2.2.0...
Need help?
Do you have a question about the WLED150CV1 and is the answer not in the manual?
Questions and answers