Caroma Sydney Smart II 987150 Plumbers Installation Instructions

Sydney Smart II One Piece
1.28/0.8 gpf (4.8/3 lpf) Easy
Height Elongated Toilet
#987150
Vitreous China Dual Flush
High Efficiency (HET)
Washdown Toilet
PLUMBER'S INSTALLATION INSTRUCTIONS. PLEASE
READ CAREFULLY BEFORE INSTALLATION.
Rough in:
It is possible to fix the toilet into a 10" (255mm) or 12" (305mm)
rough in position by rotating the offset adaptor.
IMPORTANT:
A reducing wax ring MUST NOT be used when installing this
toilet bowl as detailed in Fig.2.
Working Water Pressure:
USA & Canada: Recommended working water pressure is
20-80psi (140-550Kpa).
Flushing Operation:
Push down the big button for a full flush (1.28 gpf / 4.8 lpf)
and the small button for a reduced flush (0.8 gpf / 3 lpf).
Installation Procedure:
1. It is important for installation of Sydney Smart II 1 PC
Washdown toilet that the closet flange be accurately set
out from the finished wall as detailed in Fig.3.
2. Position wax seal and offset adaptor onto "T" bolts as
detailed in Fig. 4 and 5, ensuring that the offset adaptor is
positioned for a 10" (255mm) or 12" (305mm) rough in as
detailed in Fig.1.
3. Place fixing bracket onto "T" bolt and secure it by hand,
tightening nuts and washers onto the "T" bolts. Apply an
additional turn for final installation as detailed in Fig.5.
4. Ensure that the area around the closet bowl is clean and
free from building materials.
5. Accurately align the closet bowl over the offset adaptor
and lower into position.
6. Insert the plastic bushing and brass bushing into the Bowl
fixing hole as shown in Fig.6. Secure the bushings through
the holes in fixing bracket with stainless steel screws as shown
in Fig. 7. Cover the holes with caps.
7. It is recommended that a bead of silicone caulking is
applied fully around base of the closet bowl.
8. Remove any excess silicone caulking.
Fixing Bracket Assembly
Caroma International Pty Ltd. ABN 90 35 053 413 157
5-1/2"
(140mm)
14-1/8"
(360mm)
Fig.1
Standard Wax Bowl
Ring
Reducing Wax Bowl
Ring
Fig.2
Finished Wall
'T' Bolt
Wax Seal
Closet Flange
Fig.4
Caravelle Bowl
Plastic
Bushing
Cap
Brass Bushing
Stainless Steel Screw
Fig.6
10-3/4"
(272mm)
3/4"
(20mm)
11" (280mm)
10"(255mm)
12"(305mm)
Finished Wall
Closet Flange
Fig.3
Finished Wall
Adaptor
Fixing
Fig.5
Bracket
Fixing
Bracket
Fig.7
Date of Issue: May 2019