Bringing Into Use; Preparing The Cartridge (Fig. B); Inserting The Cartridge (Fig. C); Switching The Device On And Off - Parkside PAP 6 A1 Operation And Safety Notes

©

Bringing into use

©

Preparing the cartridge (Fig. B)

Cut the cartridge with a sharp knife.
Screw the nozzle on to the cartridge.
Cut the point of the nozzle to the desired length.
Note: The internal diameter of the point
should be ‗ > 3 mm. We recommend that the cut
is made at an angle of 45°. This is intended as
indicative information only. The actual values
used will depend on the layout and dimensions
of the surfaces you are working on.
Note: If you reuse a previously used cartridge,
clear the blocked point with a thin, sharp knife.
©

Inserting the cartridge (Fig. C)

Screw the cartridge tube
Pull the piston back into its starting position.
11
Insert the cartridge into the cartridge tube
as far as it will go.
Screw the cartridge tube
device.
©
Switching the device on and off
If necessary unlock the ON / OFF switch
by moving the safety lock-out
Switching on:
To start the device, press the ON / OFF switch
and keep it pressed.
Switching off:
To switch off the device, release the ON / OFF
switch .
5
The amount of material remaining in the cartridge can
be gauged from the piston feed rate indicator
The longer the red bar, the lower the remaining
amount of material.
Bringing into use / Care and cleaning / Service
off the device.
10
10
back on to the
10
5
downwards.
4
5
.
12
©

Applying sealant / adhesive

Set the desired speed on the feed rate selector
wheel .
1
Hold the device at a slight angle to the surface
about to receive the sealant/adhesive.
Press the ON / OFF switch
piston moving.
Guide the device along at a steady speed.
Ensure that the sealant is applied in such a way
that it is in full contact with the two surfaces.
Release the ON / OFF switch
plying the sealant / adhesive.
©

Care and cleaning

½
Always pull the mains adapter with mains plug
out of the mains socket and remove the re-
9
chargeable battery pack before you clean or
perform any tasks on the device.
The cordless caulking gun is maintenance-free.
Always keep the device clean, dry and free of
oil or grease.
Clean the device immediately after you have
finished using it.
Do not allow any liquids to enter the device.
Use a cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.
Keep the cartridge tube
it with a moist clean cloth.
©

Service

Have your device repaired
at the service centre or by qualified
specialist personnel using original
manufacturer parts only. This will ensure
that your device remains safe to use.
If the plug or lead needs to
be replaced, always have the replace-
ment carried out by the manufacturer
or its service centre. This will ensure that
your device remains safe to use.
to start the
5
to cease ap-
5
clean by cleaning
10
GB 11