TP-Link Festa F65-Wall V1 Quick Installation Manual

Quick Installation Guide
Wireless Wall Plate Access Point
Note: Festa F65-Wall is used as an example throughout the installation.
©2024 TP-Link 7106511042 REV1.0.0
1 Hardware Overview
Front Panel
RESET Button
With the AP powered on, press and hold the button for about 5 seconds until the LED
flashes, then release the button. The AP will restore to factory default settings.
LED/Wi-Fi Button
When the AP is working in Standalone Mode and enabled with Wi-Fi Control, press the
button to turn on/off both the Wi-Fi and LED. In the other cases, press the button to turn
on/off the LED only.
LAN Ports
Wired devices can be connected to the LAN ports via Ethernet cables and access the
network.
LED Indicator
On: Working normally/Initializing.
Off: Working abnormally/Power off/LED is turned off.
Flash:
• Flash twice: Initialization is completed.
• Flash once per second: The AP is upgrading.
• Flash quickly: The AP is resetting or the Festa controller is locating the AP*.
* When the Locate feature is activated in the Festa controller, the LED flashes quickly to
locate and identify the device. The LED will flash for 10 minutes, or you can disable the
feature manually to stop it flashing.
Images may differ from your actual product.
RESET Button
LED/Wi-Fi Button
LED
LAN Ports
Rear Panel
ETH0 (PoE IN) Port
Connected to a PSE (Power Sourcing Equipment), such as a PoE switch, for both
data transmission and Power. The PSE supports 802.3af/at inputs and complies with
Power Source Class 2 ( PS2) or Limited Power Source (LPS) of IEC 62368-1.
2
Hardware Installation
Before installation, be sure that you have the following items:
• A pre-installed wall junction box
• An RJ45 plug
• A Phillips screwdriver
• A PoE switch
The AP can be mounted into a wall junction box. The junction box should
be pre-installed with a running-in-wall Ethernet cable connected to a PoE
switch.
Common wall junction boxes:
86 mm
Wall Junction Box Wall Junction Box
Safety Information
• Keep the device away from water, fire, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device. If you need
service, please contact us.
• Do not use the device where wireless devices are not allowed.
Standard EU Standard US
Wall Junction Box