Page 2
The device is shipped with the batteries installed and a pull tab on the positive terminal of the battery. Removing the pull tab will activate the device. There is no need to open the enclosure to activate the device. External Connector (COMFORT only) Remove the battery tabs from the Smart Room Sensors...
Page 3
Activation & Troubleshooting Commissioning the Device Using LeapX Application To use LeapX, you will need a TEKTELIC Account. If you don’t have an account already, please raise a ticket in our support portal support.tektelic.com and our support team will create an account for you.
Page 4
Table 1: Default Reporting for the the VIVID Smart Room Sensor COMFORT Smart Room Sensor The default reporting periods is set to reporting every 60 minutes. To make changes to the default reporting periods, please refer to the knowledge base on the support portal,...
Need help?
Do you have a question about the COMFORT and is the answer not in the manual?
Questions and answers