Connecting Headphones; Mounting Two Quadpacks Into A Rack - Sennheiser QUADPACK QP 3041 Instruction Manual

Connecting headphones

For monitoring the audio signals of the mounted receivers, connect a pair of
headphones to the headphone output
either separately or simultaneously.
Turn the headphone volume control
ble.
Connect the headphones to the headphone output
Press the monitor keys (RX 1 to RX 4)
wish to monitor. The color of the control LEDs
monitor keys changes from red to green.
Slowly turn the headphone volume control
reached the desired volume.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than
with loudspeakers. Listening at high volume levels for long periods can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.

Mounting two Quadpacks into a rack

With the rack-mounting kit (see „Accessories" on page 31), two Quadpacks
can be mounted side by side into a 19
Place the two Quadpacks side by side onto a table, their bottom sides
facing upwards.
Put the mounting plate
fix it to the Quadpacks by means of the eight supplied screws.
Screw the two rack mount "ears"
If you wish to operate the two Quadpacks with a pair of antennas moun-
ted to the front of the rack (see below), fix the two cables
3030 AM antenna mount to the rack mount "ears"
diagram on the left.
Mount the system into a 19
. The audio signals can be monitored
counter-clockwise as far as possi-
next to the receivers that you
clockwise until you have
"
rack.
onto the bottom sides of the Quadpacks and
to the two connected Quadpacks.
"
rack and screw it tight.
.
below the pressed
of the GA
as shown in the
25