Changing The Receiving Frequency - Sennheiser EM 3031-U Instructions For Use Manual

9

Changing the receiving frequency

To change the receiving frequency, please proceed with the following steps:
Press button
With buttons
to the next fixed frequency setting in the program. 8 channels are allocated to each range.
The 4 possible ranges are always shown by the display
Have you set the frequency correctly? Then press button
seconds. Your entry is confirmed by the fact that the text "
the same time, "
Only now does the receiver change to the new frequency, any existing RF link to a
transmitter on the previous frequency is interrupted.
You can discontinue your entry at any time by briefly pressing button
is briefly confirmed on the display panel
operation and the text "
appears again.
After about 5 seconds, the receiver then automatically returns to normal operation if no entry has
been made during this period. Here, too, "
again.
(" "). The text "
FREQUENCY MHZ
SET
( you can now select a different frequency. The display always jumps
/ )
" appears and the other displays in display panel
SŠł
" ceases to flash. The frequency to which the receiver was set
FREQUENCY MHZ
ESC
" in display panel
with " ". The receiver switches back to normal
ESC
" flashes briefly. You must then begin operation over
begins to flash.
in display panel
(" ") again for about 3
SET
" ceases to flash. At
FREQUENCY MHZ
go off briefly.
(" "). The cancellation
SET
.
39